The discharge plate is the piece of steel that’s underneath the insulator, it causes the steel object to attempt to discharge, however for the reason that plastic is in the way in which it makes the electrical energy spark out making an attempt to succeed in the naked steel.
In this step you have to:
Speaker Wire (2″
With the ducttape, kneel on the ground with the steel plate vertical between your knees and fold the ducctape over the hotdog approach’ in order that half of the ducttape is on the entrance and half of it’s on the again. I went over every edge twice for added thickness however you do not have to. Repeat this steps on the entire sides apart from 1. The facet you do not tape needs to be one of many shorter sides.
Now set the plate down on a desk with the tape-free facet dealing with you. On the decrease proper nook slice off the final inch of tape (proven in image three) take away the tape on that final inch on the highest and the underside.
To join the speaker wire, strip each wires, about an inch lengthy and tape one among them to the highest of the plate and the opposite to the underside (see Picture 4 and 5) after you could have linked the wires, end placing the ducttape on the final edge.
The different finish of the speaker wire you have to to strip and wind the 2 separate half of the wire collectively, this finish will go to the NEGATIVE terminal of your transformer.
If you dont know which finish is the damaging, discover a grounded object and contact every finish of the transformer to the grounded object, one among them will spark, the opposite one will do nothing, join the plate’s wire to the one which does nothing.