How to handle your robotic vacuum

Google+ Pinterest LinkedIn Tumblr +

Though your robot vacuum might not be as refined because the droids in sci-fi movies, they nonetheless want common upkeep. Without it, your vacuum would possibly find yourself simply pushing grime round, as a substitute of choosing it up.

Your foremost focus when taking good care of your Roomba, Shark, Botvac or different automated vacuum is the maintenance of the wheels, foremost brush and facet brushes. Here’s learn how to get began.

Wheels

When wheels get dirty, they will not flip as nicely. To maintain them spinning, at the very least as soon as every week make sure that there are no threads or hairs wrapped across the axles. If there are, use a utility knife to chop the particles free.  

Next, examine to see if there’s something caught to the wheels themselves. If so, wipe them down with a moist material. Clean wheels get higher traction and forestall additional pressure on the motor.

robot-vac

Use a utility knife to free hair and strings from brushes and wheels.


Alina Bradford/CNET

Main brush

All robotic vacuums have at the very least one foremost brush that pulls grime, lint and hair into the mud cup. Like the wheels, the principle brush can get entangled with hair and strings. After each use, examine the principle brush and lower away something wrapped round it. Be positive to not lower the bristles as you’re employed.

Once a month, take away the principle brush – if the handbook says you possibly can – and hand wash it in heat water and gentle dish cleaning soap. Give it an excellent rinse, then let it air dry absolutely earlier than placing it again into the vacuum.

Side brushes

The facet brushes on a robotic vacuum are smaller and are used to drag particles into the principle brush’s attain. They want some additional care to maintain working nicely.

After a when you could discover that these brushes grow to be warped and even tangled. Luckily you possibly can straighten them again out, no downside. Heat the plastic bristles for a couple of seconds with a blow dryer set on excessive. When they’re heat, coax the bristles again into place together with your fingers. Hold them in place for a couple of seconds till they cool, which can set them in place.


Now Playing:
Watch this:

Dyson’s new Cyclone V10 stick vac now has extra suction…


1:23

A couple of minutes of maintence each week and month will maintain your robotic vacuum buzzing alongside for years to come back.

Source link

Share.

Leave a Reply

%d bloggers like this: